Environmental standards & speed delivery & free installation. [email protected]
News
  1. Home > 
  2. Shaking Table Test Of 1
Other

Shaking Table Test Of 1

A 12scale model of a twostory selfcentering reinforced concrete frame model was designed and tested on the shaking table in State Key Laboratory of Disaster Reduction in Civil Engineering at Tongji University to evaluate the seismic behavior of the structure

Contact Us
About Us

Our Capacity

Under strict quality control system, we are responsible for every part, every process, every product and every customer. Welcome to visit our company and factory.

Introduction of shaking table test of 1
  • Shaking Table Test of a 120 Scale HighRise Building with
    Shaking Table Test of a 120 Scale HighRise Building with

    Nov 11 2006 A microconcrete model representing the highrise building was constructed in 120 scale Shaking table tests were conducted and the model was subjected to earthquake actions representing minor moderate major and supermajor earthquakes for a region of moderate seismicity with basic seismic intensity at the VIIth degree pursuant to GB500112001

    Get Price
  • Shaking Table Test of Scaled 15 EPS Embankment Model
    Shaking Table Test of Scaled 15 EPS Embankment Model

    Due to this earthquake many houses and roads collapsed In order to investigate the behavior of EPS embankments when a largescale earthquake acts consecutively an EPS embankment model with a scale of 15 was built and a shaking table experiment was conducted using the shaking table 3 m 2 m at the University of Tokyo

    Get Price
  • Shaking Table Test of 130 Scale Model of Palasport in
    Shaking Table Test of 130 Scale Model of Palasport in

    The dynamic stability of a timber shell roof structure of the Palasport located in Bologna has been investigated by means of reduced 130 scale model tested on seismic shaking table at Dynamic Testing Laboratory of IZIIS Skopje Macedonia The model was physically modeled according to similitude lows and Buckinghams theorem as an artificial mass simulation model using the same material as

    Get Price
  • 3D dynamic finite element analyses and 1 g shaking table
    3D dynamic finite element analyses and 1 g shaking table

    The 1 g shaking table unit and its fundamental parts used in the present study are shown in Photo 1 The dimensions of the laminar shear box of the shaking table unit are 12 m in length 10 m in width and 08 m in height Its maximum payload acceleration and displacement are

    Get Price
  • Shaking Table Testing Earthquake Engineering
    Shaking Table Testing Earthquake Engineering

    Shaking Table Testing 3 Shaking Table Actuator Harmonic wave Random wave Figure 1 Shaking table test 3 Vibration Generator Test In the case of actual buildings a vibration generator is often used to apply harmonic external forces A vibration generator is usually set up on the top of the target structure as shown in Fig 2

    Get Price
  • Shaking Table Model Test on the Dynamic Soil
    Shaking Table Model Test on the Dynamic Soil

    the performance requirements of the shaking table 4 Requirements of construction and capability of equipment must be accessible in laboratory Consequently nongravity model of nonprototype materials is adopted in the present test Similitude Table 1 Test Objectives and Arrangement

    Get Price
  • Shaking Table Test of GFRP Reinforced Concrete Frame
    Shaking Table Test of GFRP Reinforced Concrete Frame

    Reset your password If you have a user account you will need to reset your password the next time you login You will only need to do this once

    Get Price
  • PDF Shaking Table Test of a 1235 Scale 4Story
    PDF Shaking Table Test of a 1235 Scale 4Story

    Due to the table limit the scale factor of the model is chosen as 1 235 of a prototype The shaking table test of the scaled model of the building is carried out under several ground motions to

    Get Price
  • LARGESCALE SHAKING TABLE TEST OF STEEL BRACED
    LARGESCALE SHAKING TABLE TEST OF STEEL BRACED

    Shaking Table Tests To further examine the performance of the controlled rocking frame system a large 23 scale threestory frame was tested at the EDefense facility in Miki Japan

    Get Price
  • Shaking Table Test of a 1235 Scale 4Story Building
    Shaking Table Test of a 1235 Scale 4Story Building

    conventional frame system in four storeys on a shaking table The building has been modelled before construction Due to the table limit the scale factor of the model is chosen as 1235 of a prototype The shaking table test of the scaled model of the building is carried out under several ground motions to verify the safety of the system

    Get Price
  • STUDY AND ANALYSIS ON SHAKING TABLE TESTS OF
    STUDY AND ANALYSIS ON SHAKING TABLE TESTS OF

    The time interval of the test is 000388s Lu et al 2002 Summary of Test Results The container and model fixed on the shaking table is shown in Fig5 The summary of some important findings from SSI system tests is presented as follows It should be noted that only parts of test evidences are described here due to the limitation of paper length

    Get Price
  • Shaking table test on seismic response of reducedscale
    Shaking table test on seismic response of reducedscale

    Now we planed parametric shaking table tests with small scale models Experimental parameters of the models can be natural period number of stories stiffness distribution along the height etc In this paper part of the experimental results are reported and discussed 2 Specimen and experimental procedures 21 Specimen Figure 1 shows the

    Get Price
  • Shaking Table Test of a 1235 Scale 4Story Building
    Shaking Table Test of a 1235 Scale 4Story Building

    Due to the table limit the scale factor of the model is chosen as 1235 of a prototype The shaking table test of the scaled model of the building is carried out under several ground motions to verify the safety of the system The simulated motions were applied to

    Get Price
  • Shaking Table Testing Earthquake Engineering
    Shaking Table Testing Earthquake Engineering

    Shaking Table Testing 1 1 Overview 1 Introduction The seismic response of a building structure depends on its dynamic properties and characteristics of input ground motions Nowadays the dynamic properties of structures can be easily calculated using computer software However various uncertain factors disturb the

    Get Price
  • Shaking Table Test of a RC Box Shear Wall under Uni
    Shaking Table Test of a RC Box Shear Wall under Uni

    D6 Youngs modulus 198x10 5 Nmm2 Shaking Table The outline of the shaking table used in this study is shown in Fig3 and the capacity of the shaking table is shown in Table 2 Generally in shaking table tests the motion of the table is generated by not only drive force from actuators but also reaction force from the specimen

    Get Price
  • Shaking table test and numerical simulation of a 12scale
    Shaking table test and numerical simulation of a 12scale

    A 12scale model of a twostory selfcentering reinforced concrete frame model was designed and tested on the shaking table in State Key Laboratory of Disaster Reduction in Civil Engineering at Tongji University to evaluate the seismic behavior of the structure

    Get Price
  • Research Shaking Table Tests on Piles WSDOT
    Research Shaking Table Tests on Piles WSDOT

    This research was undertaken to explore the interaction behavior of soilpile systems subjected to static and dynamic lateral loads The principal objective of the study was to assess the applicability and accuracy of one of the prominent methods of analysis by comparing the predicted responses with the measured responses

    Get Price
  • 1g shaking table tests on seismic enhancement of existing
    1g shaking table tests on seismic enhancement of existing

    The shaking table test device used in the present study is shown in Fig has the maximum payload acceleration and displacement of 16 kN 98 ms 2 and 005 m respectively The dimensions of the shaking table shear box are 12 m in length 10 m in width and 08 m in order to prepare a uniform model ground with a prescribed density a sanddropping device placed on the updown

    Get Price
Hot Product
  • Slag Dryer
    Slag Dryer

    Production Capacity: 10-30TPH

    Humidity of Raw Materias: 20±3(%)

  • Sawdust Dryer
    Sawdust Dryer

    Processing Capacity:2.5-50TPH

    Application Area: industries of wood, slag, sand, construction materials, metallurgy, chemical engineering, coal, minerals, etc.

  • Slurry Dryer
    Slurry Dryer

    Cylinder Capacity:9-285m³

    Production Capacity: 1.9-76TPH

  • Lithium Ore Processing Equipment
    Lithium Ore Processing Equipment

    Capacity:0.18-7 (m ³/min)

    Suitable Materials:Lithium, copper, zinc, lead, nickel, gold and other non-ferrous metals, ferrous and non-metal.

Hot News
Next Post

Lime Kiln Road Closure June 17Thaugust 9Th

Rotary Kiln
Previous Post

Explore Grinders For Concrete

Grinding Mill
CONTACT US

WE OFFER VARIOUS MINING MACHINES